| Online Catalog | Fast Entry | Order History | Get Quote | View Cart | Logout |
|
Connector Wiring Instructions |
|
|
|
|
|
Step 1. Slide nut, gasket (with V groove toward cable end) over cable jacket as shown. Cut and strip cable jacket to .28 length as shown. |
|
|
Step 2. Comb out braid and fan out radially. Cut and strip dielectric to
expose .16 conductor length. Do not nick conductor.
|
 |
|
Step 3. Pull braid forward and taper toward conductor then slide clamp over
braid (tapered end first) and bottom out
against cable jacket.
|
 |
|
Step 4. Fold braid back over clamp and trim to .13 length. Wet conductor using a
non acid core 60 - 40 tin lead solder, then slide contact on and solder in
place. Do not overheat cable dielectric as swelling may prevent insertion of
cable into shell.
|
|
|
Step 5. With gasket properly seated on clamp, slide cable assembly into shell as
far as it will go. Slide nut into shell and screw in place with wrench until tight. Make sure to hold cable and shell rigid
while rotating nut.
|
 |
